NoLimitNodesDocs

Configure Shredstream in the Dashboard

Register, replace, and remove your account-wide Shredstream UDP destination.

Before you start

You need an Ultra trial, paid Ultra plan, or eligible Enterprise account. Prepare:

  • A public IPv4 address
  • A UDP port from 1 through 65535
  • A receiver listening on that port
  • A firewall and network route that allow inbound UDP

Private, loopback, multicast, reserved, broadcast, hostname, IPv6, malformed, and out-of-range targets are rejected.

Register the destination

  1. Open Dashboard → Shredstream.
  2. Enter the public IPv4 address.
  3. Enter the UDP port.
  4. Select Start delivery.

Provisioning begins immediately. No staff approval is required.

Read the status

StatusMeaning
not_configuredNo destination exists
provisioningThe gateway is applying the destination
activeThe destination is active
errorProvisioning failed. Review the displayed error and retry

Replace a destination

Enter the replacement IP and port, then save. The gateway atomically replaces the previous destination.

Stop delivery

Select Stop delivery and confirm. NoLimitNodes removes the destination from the delivery gateway.

Downgrading, canceling, or ending an unconverted Ultra trial also removes the destination.